REMOVAL & INSTALLATION
Fig. Fig. 1 Exploded view of the front sway bar mounting
Jack up the front end of the car and safely support it with jackstands.
Disconnect each side of the sway bar linkage by removing the nut from the link bolt. Pull the bolt from the linkage and remove the retainers, grommets and spacer.
Remove the bracket-to-frame or body bolts on both sides of the car and remove the sway bar, rubber bushings and brackets.
To install, reverse the removal procedure. Make sure the rubber bushings are installed squarely in the bracket with the slit in the bushings facing the front of the car. Tighten the sway bar link nuts to 13 ft. lbs.