Ridgeline 2007-2008

Exterior

Print

Back-up, Brake, Marker, Signal, & Tail Lights



Removal & Installation
Tail Lights
  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Open the tailgate.
  4.  
  5. Remove the taillight bolts, pull taillight toward you to release two clips.
  6.  
  7. Unplug the taillight connecter.

    Click image to see an enlarged view

    Fig. Taillight fastener locations

  8.  

To install:

  1. Connect the taillight connecter.
  2.  
  3. Install the pushing away from you to fasten the two clips.
  4.  
  5. Install the taillight bolts
  6.  
  7. Close the tailgate.
  8.  

Headlights



Aiming

Specific to:

Honda Ridgeline 2006-2008

  1. Park the vehicle on a level surface.
  2.  
  3. Make sure the tire pressures are correct.
  4.  
  5. The driver or someone who weighs the same should sit in the driver's seat.
  6.  
  7. Clean the outer lens so that you can see the center of the headlights.
  8.  
  9. Park the vehicle in front of a wall or a screen.
  10.  
  11. Turn the low beams on.
  12.  
  13. Determine if the headlights are aimed properly.
  14.  
  15. Measure the vertical adjustment height of the headlights (A). The lights should reflect 2.1 in (52 mm.) below headlight height (B).

    Click image to see an enlarged view

    Fig. Measure the vertical adjustment height of the headlights

  16.  
  17. If necessary, open the hood and adjust the headlights by turning the vertical adjuster.

    Click image to see an enlarged view

    Fig. Headlight vertical adjuster

  18.  

Removal & Installation

Specific to:

Honda Ridgeline 2006-2008

  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Remove the front bumper.

    Click image to see an enlarged view

    Fig. Front bumper fastener locations

  4.  
  5. Remove the corner cover (A).
  6.  
  7. Remove the connectors (B) from the headlight assembly (C).
  8.  
  9. Remove the five mounting bolts and clip, then remove the headlight.
  10.  
  11. Remove the bolt and the corner upper beam (D) from the headlight.

    Click image to see an enlarged view

    Fig. Headlight fastener locations

  12.  

To install:

  1. Install the headlight in the reverse order of removal.
  2.  
  3. Adjust the headlight aim.
  4.  

 
label.common.footer.alt.autozoneLogo