Ridgeline 2007-2008

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the precautions.
  2.  
  3. Open the glove box Remove the damper and the glove box stop on each side, then let the glove box hang down.
  4.  
  5. Disconnect the 7P connector (A) from the mode control motor (B). Remove the self-tapping screws and the mode control motor from the heater unit.

    Click image to see an enlarged view

    Fig. Mode door actuator

  6.  

To install:

  1. Install the motor in the reverse order of removal.
  2.  
  3. Make sure the pin on the motor is properly engaged with the linkage.
  4.  
  5. After installation, make sure the motor runs smoothly.
  6.  

 
label.common.footer.alt.autozoneLogo