Roadmaster 1992

Lower Control Arms

Print

Removal & Installation



At this time the manufacturer does not provide removal and installation procedures for this component. The following procedure is a guideline and may differ from the vehicle you are servicing.

  1. Before servicing the vehicle, refer to the Precautions Section.
    NOTE
    Disconnecting the negative battery cable on some vehicles may interfere with the functions of the on-board computer systems and may require the computer to undergo a relearning process, once the negative battery cable is reconnected.


    NOTE
    If working near and/or around the SRS system and components, be sure to properly disable the SRS system. See disarming/arming the SRS system.


    NOTE
    For vehicles equipped with OnStar (RPO UE1), with battery backup, the backup battery is a redundant power supply to allow limited ONStar functionality in the event of a main battery power disruption to the OnStar module (VCIM). Do not disconnect the main vehicle battery or remove the OnStar fuse with the ignition key in any position other than OFF. Retained accessory power should be allowed to time out or be disabled by opening the driver-s side door before disconnecting power. Disconnecting power to the module in any way while the ignition is ON or with the retained accessory power activated may cause activation of the OnStar backup battery system and will discharge and permanently damage the backup battery. Once the backup battery is activated it will stay on until it has completely discharged. The backup battery is not rechargeable and once it is activated, it must be replaced.

  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the front spring.

    Click image to see an enlarged view

    Fig. Front spring and related components

  6.  
  7. Disconnect the lower ball joint stud from the steering knuckle.
  8.  
  9. Remove the lower control arm from the vehicle.

    Click image to see an enlarged view

    Fig. Lower control arm and related components

  10.  

To install:


NOTE
Be sure to use new fasteners, as required.


NOTE
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread sealer are identified. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and m