Removal & Installation
Before servicing the vehicle, refer to the Precautions Section.
NOTEDisconnecting the negative battery cable on some vehicles may interfere with the functions of the on-board computer systems and may require the computer to undergo a relearning process, once the negative battery cable is reconnected.
NOTEIf working near and/or around the SRS system and components, be sure to properly disable the SRS system. See disarming/arming the SRS system.
NOTEFor vehicles equipped with OnStar (RPO UE1), with battery backup, the backup battery is a redundant power supply to allow limited ONStar functionality in the event of a main battery power disruption to the OnStar module (VCIM). Do not disconnect the main vehicle battery or remove the OnStar fuse with the ignition key in any position other than OFF. Retained accessory power should be allowed to time out or be disabled by opening the driver-s side door before disconnecting power. Disconnecting power to the module in any way while the ignition is ON or with the retained accessory power activated may cause activation of the OnStar backup battery system and will discharge and permanently damage the backup battery. Once the backup battery is activated it will stay on until it has completely discharged. The backup battery is not rechargeable and once it is activated, it must be replaced.
- Raise and support the vehicle safely.
- Properly support the rear axle using a suitable lift.
- Disconnect the level control link at the upper control arm.
- Disconnect the brake hose fitting bolt/screw at the center of the rear axle.
- Remove the lower shock absorber retaining bolt and nut.
- Remove the shock from the bracket.
Using an adjustable lifting device, lower the axle enough for the spring to be removed.
Be sure to use new fasteners, as required.
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread sealer are identified. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners.
Installation is the reverse of the removal procedure.
- Seat the bottom of the spring on the rear axle.
- Using the GM diagnostic scan tool or aftermarket equivalent reprogram the necessary systems and components. Be sure to follow the scan tool manufacturer-s directions.