S10 Pickup, Sonoma 2000-2004

Arming The System

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Attach the yellow two-way connector located behind the glove box.
  4.  
  5. Install the Connector Position Assurance (CPA) to the passenger yellow two-way connector located behind the glove box.
  6.  
  7. Turn the ignition switch to LOCK , then remove the key.
  8.  
  9. Attach the two-way connector at the base of the steering column and the Connector Position Assurance (CPA).
  10.  
  11. Install the steering column filler panel or knee bolster.
  12.  
  13. Install the AIR BAG fuse to the fuse block.
  14.  
  15. Connect the negative battery cable.
  16.  
  17. From the passenger seat, turn the ignition switch to RUN and make sure that the AIR BAG warning lamp flashes seven times and then shuts off. If the warning lamp does not shut off, make sure that the wiring is properly connected. If the light remains on, take the vehicle to a reputable repair facility for service.
  18.  

  1. Disconnect the negative battery cable.
  2.  
  3. Connect the inflatable restraint front end discriminating sensor connectors to the inflatable restraints front end discriminating sensor.
  4.  
  5. Install the CPA to the inflatable restraints front end discriminating sensor connectors.
  6.  
  7. Install the SIR fuse into the fuse block.
  8.  
  9. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
  10.  
  11. The AIR BAG indicator will flash 7 times.
  12.  
  13. The AIR BAG indicator will then turn OFF.
  14.  
  15. Perform the SIR-Diagnostic System Check if the AIR BAG indicator does not operate as described.
  16.  

 
label.common.footer.alt.autozoneLogo