SRX 2004-2005

Window Systems

Print

Door Glass & Regulator



Power Windows
Diagnosis & Testing
Window Motor


Click image to see an enlarged view

Fig. Window motor terminal identification

  1. With the ignition OFF , unplug the harness connector at the inoperative power window motor.
  2.  
  3. With the ignition OFF , test for less than 5 ohms of resistance between the power window motor ground circuit terminal 4 and ground. If greater than the specified range, test the ground circuit for an open/high resistance.
  4.  
  5. With the ignition ON , test for battery voltage between the B+ circuit terminal 1 and ground. If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  6.  
  7. If all circuits test normal, test or replace the inoperative power window motor.
  8.  

Window Switch
  1. With the ignition ON , with a scan tool, observe the appropriate window switch parameters for the driver and front passenger window switches while activating all window switches to the UP, DOWN, and EXPRESS positions. If the readings do not change as the switches are activated, replace the appropriate door control module.
  2.  

Removal & Installation
Window Motor & Regulator
Front
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise the window to the full up position.
  4.  
  5. Remove the door trim panel and water deflector. Refer to the power locks procedure.
  6.  
  7. Raise and support the window in the full up position.
  8.  
  9. Through the access holes in the inner door panel, loosen the window clamp nuts 4 revolutions.
  10.  
  11. Connect the door trim panel wiring harness.
  12.  
  13. Lower the window regulator 3/4 of the way down.
  14.  
  15. Unplug the electrical connector from the window regulator motor.
  16.  
  17. Remove the window regulator bolts.
  18.  
  19. Remove the window regulator from the door.
  20.  
  21. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. The regulator is secured by 5 screws

  22.  

Rear
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise the window to the full up position.
  4.  
  5. Remove the door trim panel and water deflector. Refer to the power locks procedure.
  6.  
  7. Tape the window in the full up position.
  8.  
  9. Engage the door trim panel wire harness connector.
  10.  
  11. Loosen the window regulator to window clamp nuts 4 revolutions.
  12.  
  13. Using the power window switch, lower the window regulator about 1/2 way down.
  14.  
  15. Unplug the electrical connector from the power window motor.
  16.  
  17. Remove the window regulator bolts.
  18.  
  19. Remove the window regulator through the rear access hole in the door panel.
  20.  
  21. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Rear window regulator mounting screws

  22.  

Window Switch

Refer to the door lock switch removal procedure.

 
label.common.footer.alt.autozoneLogo