Removal & Installation
- Before servicing the vehicle, refer to the Precautions Section.
WARNINGThe area around the Electronic Brake Control Module (EBCM) must be free from loose dirt to prevent contamination of disassembled ABS components.
Thoroughly clean all contaminants from around the EBCM.
NOTERecord the location of all brake pipes to the brake pressure modulator valve (BPMV) for use as an aid during installation.
- Remove the 2 master cylinder brake pipes (3) from the BPMV (1).
- Clean any brake fluid spillage from the BPMV (1).
- Raise and support vehicle.
- Remove the air deflector shield.
- Remove the wheelhouse liner.
- Remove the washer solvent container bracket.
- Remove the 4 wheel brake pipes (2) from the BPMV (1).
Press the retainer on the EBCM electrical connector (1).
- Rotate the EBCM connector tab (2) forward to the unlocked position.
- Disconnect the EBCM electrical connector (1) from the EBCM and position out of the way.
- Remove the front BPMV bracket nuts.
Remove the EBCM/BPMV assembly (1) from the BPMV bracket.
- Remove and discard the 4 EBCM to BPMV screws.
- Clean the surface of the EBCM/BPMV assembly.
Remove the EBCM (1) from the BPMV (2).
- Clean the seal surface of the BPMV.
- Install the EBCM (1) to the BPMV (2).
Verify that the internal pump motor connector (3) is installed into the new EBCM (1) prior to EBCM replacement.
NOTEUse New EBCM/BPMV screws after separating the EBCM from the BPMV.
Install the 4 NEW screws connecting the EBCM to the BPMV and tighten in sequence (1-4) to 44 inch lbs. (5 Nm).
NOTEVerify that the rubber isolator is installed on the BPMV. The isolator protects the EBCM/BPMV assembly from vehicle vibrations.
- Install the EBCM/BPMV assembly (1) to the BPMV bracket.
- Install the BPMV bracket nuts (2) and tighten to 89 inch lbs. (10 Nm).
- Connect the EBCM electrical connector (1) to the EBCM (2).
Rotate the EBCM connector tab (2) rearward to the locked position.
CAUTIONThe brake pipes must be fully installed to the brake pipe mounting retainers on the frame. Failure to properly retain the brake pipes may cause the pipes to contact the frame and/or the transmission resulting in possible loss of brake fluid and personal injury.
CAUTIONMake sure brake pipes are correctly connected to BPMV. If brake pipes are switched by mistake Inlet vs. Outlet, wheel lockup will occur and personal injury may result.
- Install the 4 wheel brake pipes (2) to the BPMV (1) using the locations recorded during the removal procedure and tighten to 20ft. lbs. (27 Nm).
- Install the washer solvent container bracket.
- Install the wheelhouse liner. Refer.
- Install the air deflector shield.
- Install the 2 master cylinder brake pipes (3) to the BPMV (1) using the locations recorded during the removal procedure and tighten to 20 ft. lbs. (27 Nm).
- If equipped with a brake fluid pressure sensor (4), connect the electrical connector.
- Fill and bleed the hydraulic brake system.
- Perform the Auto Bleed Procedure.
- Use an OBD II compatible scan tool to perform a system check.