SRX 2006-2007

Removal & Installation

Print

Air Temperature Door



Left Side
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the instrument panel carrier.
  4.  
  5. Remove the left air temperature actuator screws.
  6.  
  7. Remove the left air temperature actuator harness screw.
  8.  
  9. Unplug the left air temperature actuator electrical connector from the actuator.
  10.  
  11. Remove the left air temperature actuator.
  12.  
  13. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Left air temperature actuator

  14.  

Right Side
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the right closeout panel..
  4.  
  5. Remove the instrument panel compartment.
  6.  
  7. Unplug the right air temperature actuator electrical connector.
  8.  
  9. Remove the right air temperature actuator screws.
  10.  
  11. Remove the right air temperature actuator.
  12.  
  13. Installation is the reverse of removal

    Click image to see an enlarged view

    Fig. Right air temperature actuator

  14.  

Mode Actuator



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the instrument panel carrier.
  4.  
  5. Unplug the mode actuator electrical connector.
  6.  
  7. Remove the mode actuator screws.
  8.  
  9. Remove the mode actuator.
  10.  
  11. Installation is the reverse of removal.

    Click image to see an enlarged view

    Fig. Mode actuator mounting

  12.  

Recirculation Actuator



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the instrument panel compartment and closeout panel.
  4.  
  5. Remove the upper air inlet assembly bolts.
  6.  
  7. Remove the lower right air inlet assembly bolt.
  8.  
  9. Slide the assembly to the right and then lower it.
  10.  
  11. Unplug the air inlet assembly electrical connector. Rotate the air inlet assembly and remove it.
  12.  
  13. Unplug the electrical connector from the recirculation actuator.
  14.  
  15. Remove the recirculation actuator screws, then remove the actuator.
  16.  
  17. Installation is the reverse of removal

    Click image to see an enlarged view

    Fig. Air inlet assembly



    Click image to see an enlarged view

    Fig. Recirculation actuator mounting

  18.  

 
label.common.footer.alt.autozoneLogo