SRX 2006-2007

Removal & Installation

Print

3.6L Engine



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the air cleaner outlet duct.
  4.  
  5. Unplug the cooling fan electrical connectors.
  6.  
  7. Disconnect the condenser tube from the cooling fan shroud retainer clip.
  8.  
  9. Disengage the surge tank inlet hose from the retaining features on the cooling fan shroud and reposition aside.
  10.  
  11. Remove the cooling fan shroud to radiator retaining bolts.
  12.  
  13. Remove the cooling fan assembly.
  14.  
  15. Installation is the reverse of removal. Tighten the shroud retaining bolts 58 inch lbs. (6.5 Nm).

    Click image to see an enlarged view

    Fig. Engine cooling fan-3.6L engine

  16.  

4.6L Engine



Electric Fan
  1. Remove the auxiliary cooling fan assembly to condenser upper mounting bolts.
  2.  
  3. Raise and support the vehicle.
  4.  
  5. Remove the front air deflector retainers.
  6.  
  7. Remove the front air deflector.
  8.  
  9. Unplug the auxiliary cooling fan assembly electrical connectors.
  10.  
  11. Remove the auxiliary cooling fan assembly to condenser lower mounting bolts.
  12.  
  13. Remove the auxiliary cooling fan assembly.
  14.  
  15. Installation is the reverse of removal. Tighten the shroud retaining bolts 58 inch lbs. (6.5 Nm).
  16.  

Engine Fan

NOTE
This procedure requires the use of a fan clutch wrench, special tool J41240-5A

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the air cleaner intake duct.
    NOTE
    Do not completely remove the fan from the crank adapter shaft.

  4.  
  5. Loosen the fan nut from the crank adapter shaft using J41240-5A .
  6.  
  7. Raise and support the vehicle.
  8.  
  9. Disconnect the engine wiring harness from the engine frame and reposition aside.
  10.  
  11. Continue to loosen the fan nut and disconnect the fan from the crank adapter shaft.
  12.  
  13. Remove fan from vehicle.

    Click image to see an enlarged view

    Fig. Engine cooling fan-4.6L engine

  14.  

To install:

  1. Install fan from vehicle.
  2.  
  3. Connect the fan to the crank adapter shaft.
  4.  
  5. Connect the engine wiring harness to the engine frame.
  6.  
  7. Lower the vehicle.
  8.  
  9. Tighten the fan nut to the crank adapter shaft using J41240-5A and tighten to 74 ft. lbs. (100 Nm).
  10.  
  11. Install the air cleaner intake duct.
  12.  

 
label.common.footer.alt.autozoneLogo