SRX 2006-2007

Sunroof

Print

Power Sunroof



Removal & Installation
Motor


Click image to see an enlarged view

Fig. Sunroof center panel removal

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Pull back the forward sealing strip edge of the center window panel.
  4.  
  5. Remove the 5 attaching screws.
  6.  
  7. Tip the window panel upward. Slide the window panel toward the front of the vehicle.
  8.  
  9. Remove the center window panel.
  10.  
  11. Unplug the motor/actuator electrical harness from either the front window motor/actuator or the rear vent window motor/actuator.
  12.  
  13. Remove the motor/actuator to motor/actuator block screws.
    NOTE
    The motor/actuator may need to be rocked side to side in order to release the drive gear from the cables.

  14.  
  15. Pull the sunroof motor/actuator up.
  16.  
  17. Remove the applicable motor/actuator from the motor/actuator block.
  18.  

To install:

  1. Slide the front window cable and guide assembly completely forward until the front edge of the guide assembly stops at the rear edge of the front extension.
  2.  
  3. Connect the motor/actuator electrical harness to the front window motor or to the rear vent window motor.
  4.  
  5. Install the sunroof front window motor/actuator.
  6.  
  7. Rock the motor/actuator in order to position the drive gear into the drive and driven cables of the motor/actuator block.
  8.  
  9. Install the 3 motor/actuator screws.
  10.  
  11. Install the center sunroof window.
  12.  
  13. Make sure the engine is idling and the vehicle is in park.
  14.  
  15. Press and hold the Sunroof Open Switch and the Sunshade Close Switch together for 6 seconds.
  16.  
  17. Release both buttons.
  18.  
  19. Press the Sunshade Close Switch until the motor stalls in the close position.
  20.  
  21. Press the Sunroof Close Switch until the motor stalls in the close position.
  22.  
  23. Press the Sunroof Close Switch 3 times and hold the switch down on the third switch press.
  24.  
  25. Continue holding the Sunroof Close Switch until the sunroof and sunshade have stopped moving
  26.  

Switch
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Using your fingers, gently pull downward at the front edge of the overhead console.
  4.  
  5. Unplug the electrical connectors.
  6.  
  7. Remove the overhead console.
  8.  
  9. Remove the screws securing the sunroof switch to the overhead console.
  10.  
  11. Unplug the electrical connector, then remove the switch.
  12.  
  13. Installation is the reverse of removal.
  14.  

 
label.common.footer.alt.autozoneLogo