SRX 2006-2007

Testing

Print



Click image to see an enlarged view

Fig. Fuel level sensor connector terminal identification

  1. With the ignition OFF , disconnect the harness connector at the primary and secondary fuel level sensors.
  2.  
  3. While sweeping the primary fuel level sensor through its full range of motion, test for a minimum value less than 41 ohms and a maximum value greater than 119 ohms of resistance between signal terminal A and the low reference terminal D. If not within the specified range, replace the primary fuel level sensor.
  4.  
  5. While sweeping the secondary fuel level sensor through its full range of motion, test for a minimum value less than 41 ohms and a maximum value greater than 119 ohms of resistance between signal terminal A and the low reference terminal D. If not within the specified range, replace the secondary fuel level sensor.
  6.  

 
label.common.footer.alt.autozoneLogo