SRX 2006-2007

Throttle Body

Print

Removal & Installation



3.6L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Turn the ignition OFF .
  4.  
  5. Remove the air cleaner intake duct.
  6.  
  7. Remove the throttle body electrical connector.
  8.  
  9. Unlock and reposition the wiring harness conduit.
  10.  
  11. Remove the throttle body bolts.
  12.  
  13. Remove the throttle body and gasket.

    Click image to see an enlarged view

    Fig. Throttle body mounting bolts-3.6L engine

  14.  

To install:

  1. Carefully clean the throttle body mounting surfaces of any gasket and/or seal material.
  2.  
  3. Install the throttle body and NEW gasket.
  4.  
  5. Install the throttle body bolts tighten to 89 inch lbs. (10 Nm).

    Click image to see an enlarged view

    Fig. Throttle body mounting bolts-3.6L engine

  6.  
  7. Install the wiring harness conduit.
  8.  
  9. Install the throttle body electrical connector.
  10.  
  11. Install the air cleaner intake duct.
  12.  
  13. Use a scan tool to perform the idle learn procedure and clear all DTCs.
  14.  

4.6L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the fuel injector sight shield.
  4.  
  5. Remove the air cleaner outlet duct.
  6.  
  7. Disconnect the electrical connector from the throttle body assembly.

    Click image to see an enlarged view

    Fig. Throttle body assembly-4.6L

  8.  
  9. Remove the throttle body assemble mounting bolts.
  10.  
  11. Remove the throttle body and throttle body gasket from the water housing.
  12.  
  13. Discard the throttle body gasket.
  14.  

To install:


WARNING
Do not use a cleaner which contains methyl ethyl ketone. This extremely strong solvent may damage components and is not necessary for this type of cleaning. Use a carburetor cleaner in order to remove deposits. Refer to the instructions provided with the cleaner. Do not reuse the old throttle body gasket.

  1. Install the NEW gasket to the throttle body assembly.
  2.  
  3. Install the throttle body assembly to the water housing.
  4.  
  5. Install the throttle body assembly mounting bolts tighten to 89 inch lbs. (10 Nm).
  6.  
  7. Connect the electrical connector to the throttle body assembly.
  8.  
  9. Install the air cleaner outlet duct.
  10.  
  11. Install the fuel injector sight shield.
  12.  

 
label.common.footer.alt.autozoneLogo