Saab 2000-06

Removal & Installation

Print



Click image to see an enlarged view

Fig. Removing actuator

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the glove box.
  6.  
  7. Remove the side panel from the center console.
  8.  
  9. Remove the floor air duct.
  10.  
  11. Remove both retaining bolts from the actuator.
  12.  
  13. Unplug the connector.
  14.  
  15. To install, reverse removal procedure.
  16.  
  17. Calibrate the ACC-system by simultaneously pressing the buttons AUTO and OFF .
  18.  

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the glove box.
  6.  
  7. Dismantle the floor console's front side panel on the passenger side.
  8.  
  9. Dismantle the acoustic insulation on the passenger side.

    Click image to see an enlarged view

    Fig. Locating blend door actuator

  10.  
  11. Dismantle the air duct for the floor vent and lift out the air duct through the hole for the glove box. The motor for the right hand mixed air is the motor.

    Click image to see an enlarged view

    Fig. Disconnecting motor electrical connector

  12.  
  13. Disconnect the motor's connector by pressing in the lock and pulling out the connector.
  14.  
  15. Remove the bolts from the stepping motor.

    Click image to see an enlarged view

    Fig. Removing the motor

  16.  
  17. Remove the motor from the heating and ventilation unit's link arm.
  18.  
  19. To install, reverse removal procedure.
  20.  

Left Side



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Put the air-mix control to max cold or max heat before commencing removal.
  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Remove the glove box.
  8.  
  9. Remove the data link connector, 2 screws, and the floor lighting.

    Click image to see an enlarged view

    Fig. Disconnecting electrical connector and removing motor-left motor

  10.  
  11. Unplug the motor (3) electrical connector (3).
  12.  
  13. Remove the stepping motor, 2 bolts.
  14.  
  15. To install, reverse removal procedure.
  16.  

Right Side



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Put the air-mix control to max cold or max heat before commencing removal.
  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Remove the glove box and center console. Disconnecting electrical connector and removing motor-right motor

    Click image to see an enlarged view

    Fig.

  8.  
  9. Remove the motor and 2 bolts.
  10.  
  11. Disconnect the electrical connector.
  12.  
  13. To install, reverse removal procedure.
  14.  

 
label.common.footer.alt.autozoneLogo