Santa Fe, Vera Cruz 2006-2008

Ignition Lock Cylinder

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery terminal.
  4.  
  5. Remove the crash pad side cover.
  6.  
  7. Remove the ignition switch after loosening the screw and disconnecting the 6P connector.
  8.  
  9. Remove the steering column shaft.
  10.  
  11. Remove the key warning switch and key illumination lamp after loosening the screws and disconnecting the 6P connector.
  12.  
  13. Remove the key lock cylinder after pushing the lock pin with the key ON.
  14.  
  15. Installation is the reverse of removal procedure.
  16.  

 
label.common.footer.alt.autozoneLogo