Santa Fe, Vera Cruz 2006-2008

Bleeding

Print

Specific to:

Hyundai Santa Fe 2006-2008

Hyundai Veracruz 2007-2008


CAUTION
The fluid level should be checked with the engine OFF to prevent injury from moving components. Use only PSF-3 power steering fluid, or equivalent. Do not overfill.

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Wipe the reservoir fill cap clean before removal.
  4.  
  5. Fill the pump fluid reservoir to the proper level. The fluid level should be within the -FILL RANGE- listed on the exterior of the reservoir when the fluid is at normal ambient temperature, approximately 70-80°F (21-27°C).
  6.  
  7. Let the fluid settle in the system for at least 2 minutes.
  8.  
  9. Start the engine and let it run for a few seconds. Then turn the engine OFF .
  10.  
  11. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
  12.  
  13. Raise the front wheels off the ground.
  14.  
  15. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops.
  16.  
  17. Turn the engine off. Check the fluid level and add power steering fluid if necessary.
  18.  
  19. Start the engine. Lower the vehicle and turn the steering wheel slowly from lock to lock.
  20.  
  21. Stop the engine. Check the fluid level and refill as required.
  22.  
  23. If the fluid is extremely foamy, allow the vehicle to stabilize a few minutes, then repeat the above procedure.
  24.  

 
label.common.footer.alt.autozoneLogo