Sebring 2006

Throttle Body

Print

Removal & Installation



2.4L Engines
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the clean air hose.
  6.  
  7. Remove the throttle cable shield.
  8.  
  9. Remove the throttle and the speed control cables (if equipped) from the lever and bracket.
  10.  
  11. Disconnect the electrical connectors from the idle air control motor and the Throttle Position Sensor (TPS).
  12.  
  13. Remove the throttle body to intake manifold attaching bolts.
  14.  
  15. Remove the throttle cable bracket.
  16.  
  17. Remove the throttle body.
  18.  

To install:

  1. Install the throttle body.
  2.  
  3. Tighten the throttle body mounting bolts to 120 inch lbs. (14 Nm).
  4.  
  5. Install the throttle cable bracket.
  6.  
  7. Tighten the throttle cable bracket mounting bolts to 125 inch lbs. (14 Nm).
  8.  
  9. Hold the throttle lever in the Wide Open Throttle (WOT) position and install the throttle and speed control cables (if equipped).
  10.  
  11. Connect the electrical connectors to the idle air control motor and TPS.
  12.  
  13. Install the throttle cable shield.
  14.  
  15. Install the clean air hose to the throttle body.
  16.  
  17. Connect the negative battery cable.

    Click image to see an enlarged view

    Fig. Throttle body-2.4L engine

  18.  

2.7L Engine
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative cable from the battery
  4.  
  5. Disconnect the electrical connectors from the throttle body.
  6.  
  7. Disconnect the clean air hose from the throttle body.
  8.  
  9. Remove the throttle cable shield.
  10.  
  11. Hold the throttle lever in the wide open position. Remove the throttle cable and the speed control cables from the throttle arm.
  12.  
  13. Remove the throttle cable bracket.
  14.  
  15. Remove the throttle body support bracket from the bottom of the throttle body.
  16.  
  17. Remove the remaining 2 throttle body bolts.
  18.  
  19. Remove the throttle body.
  20.  
  21. Clean the mating surfaces.

    Click image to see an enlarged view

    Fig. Throttle body-2.7L engine

  22.  

To install:

  1. Install the 2 throttle body bolts (upper right and lower bolt).
  2.  
  3. Install the throttle cable bracket.
  4.  
  5. Install the third throttle body bolt and the throttle body support bracket to the bottom of the throttle body.
    1. Tighten the lower support bracket bolts to 23 ft. lbs. (31 Nm).
    2.  
    3. Tighten the throttle body bolts to 120 inch lbs. (14 Nm).
    4.  

  6.  
  7. Hold the throttle lever in the Wide Open Throttle (WOT) position. Install the throttle cable and the speed control cable.
  8.  
  9. Install the throttle cable shield.
  10.  
  11. Connect the electrical connectors to the throttle body.
  12.  
  13. Install the clean air hose to the throttle body.
  14.  
  15. Connect the negative cable to battery.
  16.  

 
label.common.footer.alt.autozoneLogo