Sebring 2006

Windshield Wiper Systems

Print

Removal & Installation



Wiper Motor
  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect and isolate the battery negative remote cable.
  4.  
  5. Remove the wiper arms and blades.
  6.  
  7. Remove the cowl screen.
  8.  
  9. Remove the 2 wiper motor assembly mounting screws.
  10.  
  11. Lift the wiper motor assembly to gain access to the wire harness clip.
  12.  
  13. Disconnect the harness clip from the forward mounting leg.
  14.  
  15. Disconnect the wire connector at the wiper motor and remove the assembly.
  16.  

To install:

  1. Connect the wire connector at wiper motor.
  2.  
  3. Connect the harness clip to the forward mounting leg.
  4.  
  5. Place wiper motor assembly into position.
  6.  
  7. Install the 2 mounting bolts. Tighten the mounting bolts to 89-106 inch lbs. (10-12 Nm).
  8.  
  9. Install the cowl screen.
  10.  
  11. Install the wiper arms and blades.
  12.  
  13. Connect the battery negative remote cable.
  14.  
  15. Verify vehicle and system operation.
  16.  
  17. If necessary, adjust the wiper arms.
  18.  

 
label.common.footer.alt.autozoneLogo