Nissan Sentra 2007-2012
Garage Jack and Safety Stand and 2-Pole Lift
Park the vehicle on a level surface when using the jack. Make sure to avoid damaging pipes, tubes, etc. under the vehicle.
Never get under the vehicle while it is supported only by the jack. Always use safety stands when you have to get under the vehicle.
Place wheel chocks at both front and back of the wheels on the ground.
When lifting the vehicle, open the lift arms as wide as possible and ensure that the front and rear of the vehicle is well balanced.
When setting the lift arm, do not allow the arm to contact the brake tubes, brake cable, fuel lines and sill spoiler.
There is a canister just behind Garage jack point rear. Jack up carefully.
Make sure vehicle is empty when lifting.
The board-on lift attachment (LM4086-0200) set at front end of vehicle should be set on the front of the sill under the front door opening.
Position attachments at front and rear ends of board-on lift.
Fig. Board on attachment special tool LM4086-0200
Fig. Safety stand attachment special tool LM4519-0000
Fig. Vehicle lifting points
Fig. Lift attachments positioning points