Sentra 2007

Control Assembly

Print

Removal & Installation



  1. Remove center console assembly. Refer to Instrument Panel in the Body Section.
  2.  
  3. Disconnect parking brake switch connector.
  4.  
  5. Loosen adjusting nut.
  6.  
  7. Remove equalizer from rear cable terminal ends.
  8.  
  9. Remove device assembly nuts, then remove device assembly.
  10.  
  11. Remove rear brake drum or disc rotor.
  12.  
  13. Remove rear cables from the operating levers.
  14.  
  15. Remove rear cable bolts, and then remove LH and RH rear cables.
  16.  
  17. If replacing LH or RH cable guide, remove carpet and floor insulator.
    1. Remove bracket nuts and bracket.
    2.  
    3. Remove cable guide bolts and cable guides.
    4.  

  18.  
  19. Remove adjusting nut, and discard, remove front cable from device assembly (if replacing front cable assembly).
    NOTE
    Do not reuse the adjusting nut.



    Click image to see an enlarged view

    Fig. Exploded view of the parking brake control components

  20.  

To install:


NOTE
Do not reuse the adjusting nut.

  1. Install adjusting nut, install front cable to device assembly (if replacing front cable assembly).
  2.  
  3. If replacing LH or RH cable guide, remove carpet and floor insulator, then perform the following:
    1. Install cable guide bolts and cable guides.
    2.  
    3. Install bracket nuts and bracket.
    4.  

  4.  
  5. Install rear cable bolts, and then install LH and RH rear cables.
  6.  
  7. Install rear cables to the operating levers.
  8.  
  9. Install rear brake drum or disc rotor.
  10.  
  11. Install device assembly nuts, then install device assembly.
  12.  
  13. Install equalizer to rear cable terminal ends.
  14.  
  15. Tighten adjusting nut.
  16.  
  17. Connect parking brake switch connector.
  18.  
  19. Install center console assembly. Refer to Instrument Panel in the Body Section.
    NOTE
    Adjust clearance of rear brake shoes after installation.

  20.  

 
label.common.footer.alt.autozoneLogo