Sierra, Silverado 2006-2007

4.3L V6 VIN X Std 4

Print

Trouble Code: P0463



Fuel Level Sensor 1 Circuit High Voltage

Possible Causes:



Use the Freeze Frame/Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame/Failure Records data may help in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also help in determining the number of ignition cycles that the diagnostic test reported a pass and/or fail. Operate the vehicle within the same freeze frame conditions, including those for RPM, for engine load, for vehicle speed, for temperature, and for others. This will isolate at what point the DTC failed. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0464



Fuel Level Sensor 1 Circuit Intermittent

Possible Causes:



Use the Freeze Frame and/or Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame and/or Failure Records data may aid in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also aid in determining the number of ignition cycles that the diagnostic reported a pass and/or fail. Operate the vehicle within the same freeze frame conditions, i.e. RPM, engine load, vehicle speed, temperature, etc. This will isolate when the DTC failed.
 
Refer to Testing for Intermittent Conditions and Poor Connections .
 
If the DTC sets without a refueling event, refer to Fuel Gage Inaccurate or Inoperative .
 

Trouble Code: P046C



Exhaust Gas Recirculation (EGR) Position Sensor Performance

Trouble Code: P0496



Evaporative Emission (EVAP) System Flow During Non-Purge

Trouble Code: P0500



Vehicle Speed Sensor (VSS) Circuit

Possible Causes:



Ensure the VSS is correctly torqued to the transmission housing.
 

Trouble Code: P0504



Brake Switch Circuit 1-2 Correlation

Possible Causes:



Aftermarket trailer brake controllers must be disconnected before diagnosing DTC P0504 due to they could result in incorrect diagnostics.
 
Check for intermittents and poor connections. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0506



Idle Speed Low

Possible Causes:

Inspect for the following conditions:



High resistance in an IAC valve control circuit
 
Restricted air intake system
 
Proper operation and installation of all air intake components
 
Collapsed, clogged, or loose air intake ducts
 
A clogged air filter
 
Proper operation of the mass air flow (MAF) sensor, if equipped
 
A tampered with or damaged throttle stop screw
 
A tampered with or damaged throttle plate, throttle shaft, or throttle linkage
 
Objects blocking the IAC passage or throttle bore
 
Excessive deposits in the IAC passage or on the IAC pintle
 
Excessive deposits in the throttle bore or on the throttle plate
 
Vacuum leaks
 
A low or unstable idle condition could be caused by a non-IAC system problem that can not be overcome by the IAC valve. Refer to Symptoms - Engine Controls .
 

Trouble Code: P0507



Idle Speed High

Possible Causes:

Inspect for the following conditions:



High resistance in an IAC valve control circuit
 
The correct positive crankcase ventilation (PCV) valve, properly installed and proper operation of the PCV valve
 
Proper operation and installation of all air intake components
 
Proper installation and operation of the mass air flow (MAF) sensor, if equipped
 
A tampered with or damaged throttle stop screw
 
A tampered with or damaged throttle plate, throttle shaft, throttle linkage, or cruise control linkage, if equipped
 
A skewed high throttle position (TP) sensor
 
Excessive deposits in the IAC passage or on the IAC pintle
 
Excessive deposits in the throttle bore or on the throttle plate
 
Vacuum leaks
 
A high or unstable idle condition could be caused by a non-IAC system problem that can not be overcome by the IAC valve. Refer to Symptoms - Engine Controls .
 
If the problem is determined to be intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0522



Engine Oil Pressure (EOP) Sensor Circuit Low Voltage

Possible Causes:



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0523



Engine Oil Pressure (EOP) Sensor Circuit High Voltage

Possible Causes:



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help in determining how many miles since the DTC set. The Fail Counter and the Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0530



Air Conditioning Refrigerant Pressure Sensor Circuit

Possible Causes:



For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0532



Air Conditioning Refrigerant Pressure Sensor Circuit

Possible Causes:



For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0533



Air Conditioning Refrigerant Pressure Sensor Circuit

Possible Causes:



For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0540



Intake Air (IA) Heater Feedback Circuit

Trouble Code: P0601



Control Module Read Only Memory (ROM)

Trouble Code: P0602



Control Module Not Programmed

Trouble Code: P0603



PCM Internal Microprocessor Integrity

Trouble Code: P0604



Control Module Random Access Memory (RAM)

Trouble Code: P0605



Control Module Programming Read Only Memory

Trouble Code: P0606



Control Module Internal Performance

Trouble Code: P0607



Control Module Performance

Trouble Code: P0608



Vehicle Speed Output Circuit

Possible Causes:



Important: Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM connector gaskets when diagnosing/replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent water intrusion into the PCM. Using Freeze Frame and/or Failure Records data may aid in locating an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame and/or Failure Records data can aid in determining how many miles since the DTC set. The Fail Counter and Pass Counter can also aid determining how many ignition cycles the diagnostic reported a pass and/or a fail. Operate the vehicle within the same freeze frame conditions (RPM, load, vehicle speed, temperature etc.) that you observed. This will isolate when the DTC failed. For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0609



Vehicle Speed Output Circuit 2

Possible Causes:

Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to the following:



Testing for Electrical Intermittents
 
Testing for Intermittent Conditions and Poor Connections
 
Wiring Repairs
 
Connector Repairs
 

Trouble Code: P060B



Control Module Analog to Digital Performance

Trouble Code: P061C



Control Module Engine Speed Performance

Trouble Code: P062C



Control Module Vehicle Speed Performance

Trouble Code: P062F



Control Module Long Term Memory Performance

Trouble Code: P0641



5-Volt Reference 1 Circuit

Trouble Code: P0642



5-Volt Reference 1 Circuit Low Voltage

Trouble Code: P0643



5-Volt Reference 1 Circuit High Voltage

Trouble Code: P0646



Air Conditioning (A/C) Clutch Relay Control Circuit Low Voltage

Trouble Code: P0647



Air Conditioning (A/C) Clutch Relay Control Circuit High Voltage

Trouble Code: P064C



Glow Plug Module Control Performance

Trouble Code: P0650



Malfunction Indicator Lamp (MIL) Control Circuit

Trouble Code: P0651



5-Volt Reference 2 Circuit

Trouble Code: P0652



5 Volt Reference 2 Circuit Low Voltage

Trouble Code: P0653



5 Volt Reference 2 Circuit High Voltage

Trouble Code: P0654



Engine Speed Output Circuit

Possible Causes:



Important: Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM connector gaskets when diagnosing/replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent water intrusion into the PCM. Using Freeze Frame and/or Failure Records data may aid in locating an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame and/or Failure Records data can aid in determining how many miles since the DTC set. The Fail Counter and Pass Counter can also aid determining how many ignition cycles the diagnostic reported a pass and/or a fail. Operate the vehicle within the same freeze frame conditions (RPM, load, vehicle speed, temperature, etc.) that you observed. This will isolate when the DTC failed. For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0671



Cylinder #1 Glow Plug Control Circuit

Possible Causes:



If the battery is connected with the ignition ON, the glow plugs could be damaged without finding any circuit fault.
 

Trouble Code: P0672



Cylinder #2 Glow Plug Control Circuit

Possible Causes:



If the battery is connected with the ignition ON, the glow plugs could be damaged without finding any circuit fault.
 

 
label.common.footer.alt.autozoneLogo