Sierra, Silverado 2006-2007

5.3L V8 VIN J Auto 4

Print

Trouble Code: P0455



Evaporative Emission (EVAP) System Large Leak Detected

Possible Causes:



A fuel fill cap that is left OFF after a fuel fill will cause this DTC to set.
 
A loose, missing, or damaged fuel fill cap can cause this DTC to set.
 
A blockage or restriction in the EVAP purge solenoid, purge pipe EVAP canister, or vapor pipe, can cause this DTC to set.
 
A temporary blockage in the EVAP purge solenoid, purge pipe, or EVAP canister could cause an intermittent condition. Inspect and repair any restriction in the EVAP system.
 
To help locate intermittent leaks, use the J 41413-200 to introduce smoke into the EVAP system. Move all EVAP components while observing smoke with the J 41413-SPT .
 
To improve the visibility of the smoke exiting the EVAP system, observe the suspected leak area from different angles with the J 41413-SPT .
 
Observe the Freeze Frame/Failure Records vehicle mileage since the diagnostic test last failed may help determine how often the condition occurs that caused the DTC to set . This may assist in diagnosing the condition.
 

Trouble Code: P0461



Fuel Level Sensor 1 Performance

Possible Causes:



Use the Freeze Frame/Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame/Failure Records data may help in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also help in determining the number of ignition cycles that the diagnostic test reported a pass and/or fail. Operate the vehicle within the same Freeze Frame conditions, including those for RPM, for engine load, for vehicle speed, for temperature, and for others. This will isolate at what point the DTC failed. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0462



Fuel Level Sensor 1 Circuit Low Voltage

Possible Causes:



Use the Freeze Frame/Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame/Failure Records data may help in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also help in determining the number of ignition cycles that the diagnostic test reported a pass and/or fail. Operate the vehicle within the same freeze frame conditions, including those for RPM, for engine load, for vehicle speed, for temperature, and for others. This will isolate at what point the DTC failed. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0463



Fuel Level Sensor 1 Circuit High Voltage

Possible Causes:



Use the Freeze Frame/Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame/Failure Records data may help in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also help in determining the number of ignition cycles that the diagnostic test reported a pass and/or fail. Operate the vehicle within the same freeze frame conditions, including those for RPM, for engine load, for vehicle speed, for temperature, and for others. This will isolate at what point the DTC failed. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0464



Fuel Level Sensor 1 Circuit Intermittent

Possible Causes:



Use the Freeze Frame and/or Failure Records data in order to locate an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame and/or Failure Records data may aid in determining the number of miles since the DTC set. The Fail Counter and Pass Counter can also aid in determining the number of ignition cycles that the diagnostic reported a pass and/or fail. Operate the vehicle within the same freeze frame conditions, i.e. RPM, engine load, vehicle speed, temperature, etc. This will isolate when the DTC failed.
 
Refer to Testing for Intermittent Conditions and Poor Connections .
 
If the DTC sets without a refueling event, refer to Fuel Gage Inaccurate or Inoperative .
 

Trouble Code: P046C



Exhaust Gas Recirculation (EGR) Position Sensor Performance

Trouble Code: P0496



Evaporative Emission (EVAP) System Flow During Non-Purge

Trouble Code: P0502



Vehicle Speed Sensor (VSS) Circuit Low Voltage

Trouble Code: P0503



Vehicle Speed Sensor (VSS) Circuit Intermittent

Possible Causes:



Inspect for ABS DTCs. A faulty ABS condition may contribute to setting DTC P0503.
 

Trouble Code: P0506



Idle Speed Low

Trouble Code: P0507



Idle Speed High

Trouble Code: P0522



Engine Oil Pressure (EOP) Sensor Circuit Low Voltage

Possible Causes:



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0523



Engine Oil Pressure (EOP) Sensor Circuit High Voltage

Possible Causes:



Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help in determining how many miles since the DTC set. The Fail Counter and the Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail. Refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0530



Air Conditioning Refrigerant Pressure Sensor Circuit

Possible Causes:



For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0532



Air Conditioning Refrigerant Pressure Sensor Circuit

Possible Causes:



For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0533



Air Conditioning Refrigerant Pressure Sensor Circuit

Possible Causes:



For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0540



Intake Air (IA) Heater Feedback Circuit

Trouble Code: P0561



System Voltage Unstable

Possible Causes:



Inspect for aftermarket devices that could affect the operation of the starting and charging systems.
 
Inspect the wiring for poor electrical connections at the TCM. Inspect for the following conditions:

A bent terminal
 
A backed-out terminal
 
A damaged terminal
 
Poor terminal tension
 
A chafed wire
 
A broken wire inside the insulation
 

When diagnosing for an intermittent short or open, massage the wiring harness while watching the test equipment for a change.You may have to drive the vehicle in order to experience a condition.Inspect for the presence of aftermarket accessories, such as a remote starter, etc. Depending on how these aftermarket accessories are installed, they may interfere with the required voltage for proper operation of the transmission.
 

Trouble Code: P0562



System Voltage Low

Possible Causes:



Inspect the wiring for poor electrical connections at the TCM. Inspect for the following conditions:

A bent terminal
 
A backed-out terminal
 
A damaged terminal
 
Poor terminal tension
 
A chafed wire
 
A broken wire inside the insulation
 

When diagnosing for an intermittent short or open, massage the wiring harness while watching the test equipment for a change.Inspect the batteries for proper voltage.Inspect the charging system for proper operation.You may have to drive the vehicle in order to experience a condition.Inspect for the presence of aftermarket accessories, such as remote starters, etc. Depending on how these aftermarket accessories are installed, they may interfere with the required voltage for proper operation of the transmission.
 

Trouble Code: P0563



System Voltage High

Possible Causes:



Inspect the wiring for poor electrical connections at the TCM. Inspect for the following conditions:

A bent terminal
 
A backed-out terminal
 
A damaged terminal
 
Poor terminal tension
 
A chafed wire
 
A broken wire inside the insulation
 

When diagnosing for an intermittent short or open, massage the wiring harness while watching the test equipment for a change.You may have to drive the vehicle in order to experience a condition.Inspect for the presence of aftermarket accessories, such as a remote starter, etc. Depending on how these aftermarket accessories are installed, they may interfere with the required voltage for proper operation of the transmission.
 

Trouble Code: P0601



Control Module Read Only Memory (ROM)

Trouble Code: P0602



Control Module Not Programmed

Trouble Code: P0603



Control Module Random Access Memory (RAM) Failure (6L50/6L80/6L90)

Trouble Code: P0604



Control Module Random Access Memory (RAM)

Trouble Code: P0605



Control Module Programming Read Only Memory

Trouble Code: P0606



Control Module Internal Performance

Trouble Code: P0607



Control Module Performance

Trouble Code: P0608



Vehicle Speed Output Circuit

Possible Causes:



Important: Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM connector gaskets when diagnosing/replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent water intrusion into the PCM. Using Freeze Frame and/or Failure Records data may aid in locating an intermittent condition. If you cannot duplicate the DTC, the information included in the Freeze Frame and/or Failure Records data can aid in determining how many miles since the DTC set. The Fail Counter and Pass Counter can also aid determining how many ignition cycles the diagnostic reported a pass and/or a fail. Operate the vehicle within the same freeze frame conditions (RPM, load, vehicle speed, temperature etc.) that you observed. This will isolate when the DTC failed. For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections .
 

Trouble Code: P0609



Vehicle Speed Output Circuit 2

Possible Causes:

Thoroughly inspect connections or circuitry that may cause an intermittent malfunction. Refer to the following:



Testing for Electrical Intermittents
 
Testing for Intermittent Conditions and Poor Connections
 
Wiring Repairs
 
Connector Repairs
 

Trouble Code: P060B



Control Module Analog to Digital Performance

Trouble Code: P0613



Transmission Control Module (TCM) Processor

Trouble Code: P061C



Control Module Engine Speed Performance

Trouble Code: P062C



Control Module Vehicle Speed Performance

Trouble Code: P062F



Control Module Long Term Memory Performance

Trouble Code: P0634



Transmission Control Module (TCM) Internal Temperature Too High

Possible Causes:



Clean the TCM if necessary. Excessive road debris will reduce the effectiveness of the heat sink on the TCM and could cause the internal temperature to rise.
 

Trouble Code: P0641



5-Volt Reference 1 Circuit

Trouble Code: P0642



5-Volt Reference 1 Circuit Low Voltage

Trouble Code: P0643



5-Volt Reference 1 Circuit High Voltage

Trouble Code: P064C



Glow Plug Module Control Performance

Trouble Code: P0650



Malfunction Indicator Lamp (MIL) Control Circuit

 
label.common.footer.alt.autozoneLogo