Sierra, Silverado 2006-2007

Crankshaft Damper (Balancer)

Print

Removal & Installation




NOTE
A torsional damper puller tool is required to perform this procedure.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the fan shroud assembly.
  4.  
  5. Remove the fan belts, fan and pulley.
  6.  
  7. If necessary, remove the radiator.

    Click image to see an enlarged view

    Fig. Remove the accessory drive pulley bolts



    Click image to see an enlarged view

    Fig. Remove the accessory drive pulley and the damper bolt from the vehicle

  8.  
  9. Remove the accessory drive pulley (crankshaft pulley on diesel engines).
  10.  
  11. Remove the torsional damper bolt.
  12.  
  13. Remove the torsional damper using tool J-39046 or its equivalent puller.
    NOTE
    Make sure you do not lose the crankshaft key, if it has been removed.

  14.  

To install:

  1. Coat the crankshaft stub with engine oil.
  2.  
  3. Position the crankshaft key if one was used. If you pulled the crank seal, replace it with the open end facing in.
    NOTE
    The inertial weight section of the damper is attached to the hub with a rubber-like material. The correct installation procedures, with the proper tools, MUST be followed or the resultant movement of the inertial weight will destroy the tuning of the damper!

  4.  
  5. Thread the stud on the tool into the end of the crankshaft.
  6.  
  7. Position the damper on the shaft and tap it into place with a plastic mallet (lightly!). Make sure the key is in place by securing it with a little RTV sealant.
  8.  
  9. Install the bearing, washer and nut and then turn the nut until the damper is pulled into position. Remove the tool.

    Click image to see an enlarged view

    Fig. Remove the crankshaft damper using the puller tool

  10.  
  11. Make sure the damper is all the way on, then install the bolt. Refer to the Torque Specifications chart for proper tightening torque.
  12.  
  13. Install the remaining components and road test the truck.
  14.  

 
label.common.footer.alt.autozoneLogo