Solstice 2006-2008, Sky 2007-2008

Slave (Actuator) Cylinder

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Raise the vehicle.
  6.  
  7. Remove the clutch hose/pipe assembly retainer clip from the clutch actuator cylinder, (slave cylinder).
  8.  
  9. Disconnect the clutch hose/pipe assembly from the clutch actuator cylinder.
  10.  
  11. Drain the fluid from the hose/pipe assembly into a suitable container.
  12.  
  13. Remove the transmission.
  14.  
  15. Remove the clutch actuator cylinder bolts.
  16.  
  17. Remove the clutch actuator cylinder.

    Click image to see an enlarged view

    Fig. Clutch actuator cylinder, (slave cylinder) and transmission

  18.  
  19. Install the clutch actuator cylinder.
  20.  
  21. Install the clutch actuator cylinder bolts and tighten to 89 inch. lbs. (10 Nm).
  22.  
  23. Install the transmission.
  24.  
  25. Reconnect the clutch hose/pipe assembly from the clutch actuator cylinder and install retainer clip.
  26.  
  27. Check transmission fluid level and add as needed.
  28.  
  29. Lower the vehicle
  30.  
  31. Connect the negative battery cable.
  32.  
  33. Fill the brake/clutch reservoir with DOT 3 hydraulic fluid to the proper fluid level.
  34.  
  35. Bleed the clutch hydraulic system.
  36.  

 
label.common.footer.alt.autozoneLogo