Subaru Tribeca 2006

Wheel Speed Sensors

Print

Removal & Installation



Front
  1. Disconnect the ground cable from the battery.
  2.  
  3. Disconnect the ABS wheel speed sensor connector in the engine compartment.

    Click image to see an enlarged view

    Fig. Disconnect the ABS front wheel speed sensor connector in the engine compartment

  4.  
  5. Remove the (1) sensor harness from the (2) clip.

    Click image to see an enlarged view

    Fig. Remove the front wheel speed sensor harness from the clip

  6.  
  7. Remove the clip which secures the sensor harness to the front strut.
    CAUTION
    Be careful not to damage the sensor.


    CAUTION
    Do not apply excessive force to the sensor harness.

  8.  

To install:

  1. Install in the reverse order of removal. Tighten to 60 inch lbs. (7.5 Nm).
    CAUTION
    Be careful not to damage the sensor.


    NOTE
    Check the identification (mark) on the harness to make sure there is no warpage. [W1 (white)]


    NOTE
    Check if the harness is not pulled and does not come in contact with the suspension or body during steering wheel effort.

  2.  

Rear
  1. Disconnect the ground cable from the battery.
  2.  
  3. Disconnect the connector from the rear ABS wheel speed sensor.
  4.  
  5. Remove the sensor harness from the rear arm clip.

    Click image to see an enlarged view

    Fig. Remove the rear wheel speed sensor harness from the rear arm clip

  6.  
  7. Remove the rear ABS wheel speed sensor from the rear housing.
    CAUTION
    Be careful not to damage the sensor.


    CAUTION
    Do not apply excessive force to the sensor harness.



    Click image to see an enlarged view

    Fig. Remove the rear ABS wheel speed sensor from the rear housing

  8.  

To install:

  1. Install in the reverse order of removal. Tighten to 60 inch lbs. (7.5 Nm).
    CAUTION
    Be careful not to damage the sensor.


    NOTE
    Check the identification (mark) on the harness to make sure there is no warpage. [W3 (white)]

  2.  

 
label.common.footer.alt.autozoneLogo