Subaru Tribeca 2006

Oil Pressure Sensor

Print

Removal & Installation



  1. Set the vehicle on a lift.
  2.  
  3. Disconnect the ground cable from battery.
  4.  
  5. Lift-up the vehicle.
  6.  
  7. Remove the under cover.
  8.  
  9. Disconnect the terminal from oil pressure switch.

    Click image to see an enlarged view

    Fig. Disconnect the terminal from the oil pressure sensor

  10.  
  11. Remove the oil pressure switch.

    Click image to see an enlarged view

    Fig. Removing the oil pressure switch

  12.  

To install:

  1. Apply liquid gasket THREE BOND 1324 (Part No. 004403042) or equivalent to the oil pressure switch threads.
  2.  
  3. Install the oil pressure switch. Tighten to 18 ft. lbs. (25 Nm)
  4.  
  5. Connect the terminal of the oil pressure switch.
  6.  
  7. Install the under cover.
  8.  

Testing



Make sure oil does not leak or seep from where the oil pressure switch is installed.

 
label.common.footer.alt.autozoneLogo