Subaru Tribeca 2006

Sunroof

Print

Power Sunroof



Removal & Installation
Motor

CAUTION
When removing the clip, use great care not to damage the roof trim.


CAUTION
Never rotate the sunroof motor after removing it.

  1. Completely close the glass lid.
  2.  
  3. Disconnect the ground cable from battery.
  4.  
  5. Remove the spot map light.
  6.  
  7. Disconnect the harness connector, and then remove the motor assembly mounting screw.
    CAUTION
    When removing the motor assembly, secure the cable wires to prevent moves.



    Click image to see an enlarged view

    Fig. Remove the motor assembly mounting

  8.  

To install:


CAUTION
When installing the motor assembly, be careful not to move the sunroof cable.

  1. Align the (2) coulisse assembly and (3) link assembly in the same position.
  2.  
  3. Install the motor assembly.
  4.  
  5. Connect the harness connector of motor assembly, and then connect the battery ground cable to battery.
  6.  
  7. Perform the initialize operation of motor by performing the following:

    Tilt up the glass lid
     
    Release the switch once, and press the tilt up switch again for 15 seconds
     
    When the glass lid is raised a little and on tilt up position, release the switch for the moment
     
    Keep pressing the tilt up switch within 5 seconds from releasing the switch, glass lid automatically performs the tilts down, slides open, slides close operation, then the initialize operation is completed
     

  8.  
  9. Check the operation of sunroof with following:

    Glass lid closes completely; switch position, close
     
    Glass lid tilt up to the top position; switch position, tilt up
     
    Glass lid lowers completely; switch position, tilt down
     
    Glass lid opens completely; switch position, open
     
    Glass lid closes 150 mm (5.91 in) away from the completely closed position; switch position, close
     
    Glass lid closes completely; switch position, close
     

  10.  
  11. Install the trim in the reverse order of removal.
  12.  

Switch
  1. Disconnect the ground cable from battery.
  2.  
  3. Remove the spot map light lens (A) and sunroof switch mounting screws (B).
  4.  
  5. Disconnect the harness connector, and then remove the sunroof switch.
  6.  

To install:

  1. To install reverse removal procedure.
  2.  

 
label.common.footer.alt.autozoneLogo