Subaru Tribeca 2006

Removal & Installation

Print

  1. Set the vehicle on a lift.
  2.  
  3. Release the fuel pressure by performing the following:

    Remove the fuse of fuel pump from main fuse box
     
    Start the engine and run until it stalls
     
    After the engine stalls, crank it for five more seconds
     
    Turn the ignition switch to OFF
     

  4.  
  5. Disconnect the ground cable from battery.
  6.  
  7. Disconnect the ground cable from battery.
  8.  
  9. Drain fuel from fuel tank.
  10.  
  11. Remove the second row seats.
  12.  
  13. Remove the service hole cover of fuel pump.

    Disconnect the connector
     
    Remove the bolt
     
    Push the grommet down and remove service hole cover

    Click image to see an enlarged view

    Fig. Remove the service hole cover from the fuel pump

     

  14.  
  15. Remove the service hole cover of fuel sub level sensor.

    Click image to see an enlarged view

    Fig. Remove the service hole cover of the fuel sub level sensor

  16.  
  17. Disconnect the quick connector on the fuel delivery hose.

    Click image to see an enlarged view

    Fig. Disconnect the quick connector on the fuel delivery hose

  18.  
  19. Remove the rear wheels.
  20.  
  21. Lift-up the vehicle.
  22.  
  23. Remove the clip holding the harness.

    Click image to see an enlarged view

    Fig. Remove the clip holding the harness

  24.  
  25. Remove the rear suspension assembly.
  26.  
  27. Disconnect the following hoses and connectors.

    Evaporation hose (A)
     
    Fuel filler hose (C)
     
    Connector (B)
     

  28.  
  29. Remove the fuel tank from the vehicle.
    WARNING
    A helper is required to perform this work.



    Support the fuel tank with the transmission jack
     
    Remove the fuel tank band that holds the fuel tank
     
    Remove the fuel tank from the vehicle

    Click image to see an enlarged view

    Fig. Removing fuel tank bands

     

  30.  

To install:

  1. Install the fuel tank to the vehicle.
    WARNING
    A helper is required to perform this work.



    Lift the fuel tank with the transmission jack
     
    Mount the fuel tank to the vehicle with a jack
     
    Install the fuel tank band that holds the fuel tank. Tighten to 25 ft. lbs. (33 Nm)
     

  2.  
  3. Connect the following hoses and connectors:

    Evaporation hose
     
    Fuel filler hose
     
    Connector
     

  4.  
  5. Install the rear suspension assembly.
  6.  
  7. Install the clip that holds the harness.
  8.  
  9. Lower the vehicle.
  10.  
  11. Install the rear wheels.
  12.  
  13. Connect the quick connector on fuel delivery hose.
  14.  
  15. Install the service hole cover of fuel sub level sensor.
  16.  
  17. Install the service hole cover of fuel pump.

    Push the grommet to install it to the second hole cover
     
    Tighten the bolt
     
    Connect the connector
     

  18.  
  19. Install the second row seats.
  20.  
  21. Install the fuse of fuel pump to main fuse box.
  22.  
  23. Connect the battery ground cable to the battery.
  24.  

 
label.common.footer.alt.autozoneLogo