Removal & Installation
- Disconnect the ground cable from battery.
Remove the cowl panel by removing the following:
- Disconnect the connector of wiper motor assembly.
Remove the bolt, and then remove the wiper assembly.
NOTEThe wiper motor and wiper link is an assembly part and is not to be disassembled.
Install in the reverse order of removal. Tighten bolts to (T1) 60 inch lbs. (6.0 Nm) and (T2) 15 ft. lbs. (20 Nm).
Wiper rubber (1)Wiper blade assembly (2)Wiper arm (3)Wiper link assembly (4)Wiper motor assembly (5)