Subaru ff-1/1300/1400/1600/1800/Brat 1970-1984 Repair Guide

Back-Up Light Switch

Print

REMOVAL & INSTALLATION




WARNING
When removing the back-up light switch fluid may leak from the transaxle. You should first loosen the back-up light switch a few turns to see if any fluid leaks out. If this does occur retighten the switch and place an oil pan under the switch to catch the fluid before continuing with the removal and installation of the switch.

This switch is mounted on the transaxle lever shaft and is bolted to the transaxle.

  1. Disconnect the negative battery cable.
  2.  
  3. Disconnect the electrical connector and remove the old switch.
  4.  
  5. Install a new switch and reconnect the electrical connector.
  6.  
  7. Install the negative battery cable.
  8.  

 
label.common.footer.alt.autozoneLogo