Subaru ff-1/1300/1400/1600/1800/Brat 1970-1984 Repair Guide

Rear Window Wiper Motor

Print

REMOVAL & INSTALLATION





Click image to see an enlarged view

Fig. Fig. 1 Rear wiper and washer components on the Hatchback



Click image to see an enlarged view

Fig. Fig. 2 Rear wiper and washer components on the Station Wagon

  1. At the rear window, pull the wiper blade outward from the arm and press down on the clip, then remove the blade from the arm.
  2.  
  3. Remove the wiper arm cover.
  4.  
  5. Loosen the wiper arm-to-wiper assembly nut, then remove the nut and the arm from the assembly.
  6.  
  7. Remove the wiper assembly-to-rear gate cap, nut and cushion.
  8.  
  9. From inside of the rear gate, remove the wiper motor assembly trim panel.
  10.  
  11. Disengage the electrical connector from the wiper motor assembly.
  12.  
  13. Remove the wiper motor assembly-to-rear gate bolts and the motor assembly from the rear gate.
  14.  
  15. If necessary, replace the wiper motor.
  16.  
  17. To install, reverse the above procedures. With the rear wiper motor switch in the OFF position, install the wiper arm blade so that it is positioned 0.98 in. (25mm) above the rear glass molding.
  18.  

 
label.common.footer.alt.autozoneLogo