Suzuki Aerio, Verona 2002-06

Arming The System

Print

After repairs are complete, connect the negative battery cable. Turn the ignition switch to the ON position and check the SRS light for proper operation.

  1. Confirm that battery negative (-) cable is disconnected.
  2.  
  3. Turn ignition switch to -LOCK- position and remove key.
  4.  
  5. Connect yellow connector (1) of contact coil and combination switch assembly by pushing connector till clicks heard from it.

    Click image to see an enlarged view

    Fig. Connect yellow connector of contact coil and the combination switch assembly

  6.  
  7. In case of passenger air bag (inflator) module, connect yellow connector (1) of passenger air bag (inflator) module by pushing connector till click is heard from it.

    Click image to see an enlarged view

    Fig. Connect passenger air bag inflator module

  8.  
  9. Install glove box.
  10.  
  11. If equipped with side air bag (inflator) module, connect yellow connector (2) of side air bag (inflator) module by pushing connector till click is heard from it.

    Click image to see an enlarged view

    Fig. Connect side air bag inflator module

  12.  
  13. Install -AIR BAG- fuse to fuse box.
  14.  
  15. Connect negative (-) cable at battery.
  16.  
  17. Turn ignition switch to ON position and verify that -AIR BAG- warning lamp flashes 6 times and then turns OFF. If it does not operate as described, perform diagnostic system check.
  18.  


WARNING
When performing service on or around the air bag system components or wiring, disable the air bag system. Failure to follow the procedures could result in possible deployment, personal injury or unneeded system repairs.

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Connect the negative battery cable.
  4.  
  5. Turn the ignition switch to the LOCK position and remove the key.
  6.  
  7. Connect the yellow connector for the passenger side air bag (inflator) module and the yellow connector for the driver's side air bag (inflator) module. Be sure to lock each connector with the lock lever.
  8.  
  9. Install the glove box assembly.
  10.  
  11. Install the left side steering wheel side cover.
  12.  
  13. Install the AIR BAG-IG fuse in the air bag fuse box.
  14.  
  15. Turn the ignition ON and verify that the AIR BAG warning lamp flashes 7 times, then turns off. If the system does not operate as described, diagnosis and repairs to the air bag system are necessary.
  16.  

 
label.common.footer.alt.autozoneLogo