Suzuki Aerio, Verona 2002-06

Lower Control Arms

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Raise the vehicle.
  4.  
  5. Remove or disconnect the following:

    The wheel
     
    The coil spring. Refer to Coil Spring removal and installation
     
    The bolt in the sub-frame for the lower control arm
     
    The control arm
     
    The control arm rail (5740-1).

    Click image to see an enlarged view

    Fig. Removal of rear lower control arm

     

  6.  

To install:


NOTE
Tighten all joints and rubber bushings with the rear suspension in the normal position.

  1. Install or connect the following:

    The control arm rail (5742-1) in the control arm
     
    The control arm in the sub-frame. Do not tighten yet
     
    The coil spring.
     

  2.  
  3. Raise the control arms to their normal position using the tensioner 999 5659
  4.  
  5. Tighten the M12 bolt for the inner mounting for the control arm. Tighten to 59 ft. lbs. (80 Nm).
    NOTE
    If the vehicle is equipped with Bi-Xenon lamps, the position sensor must be calibrated. Carry out calibration according to VIDA Vehicle communication (Function area 3, Electrical system, Rear electronic module).

  6.  

 
label.common.footer.alt.autozoneLogo