Suzuki Esteem, Swift 1994-02

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the heater control unit from the instrument panel.
  4.  
  5. Remove the mode and temperature control cables at the heater case. Remove the cables from the vehicle.
  6.  
  7. Remove the fresh/recirculate control cable at blower case and remove from vehicle.
  8.  
  9. Installation is the reverse of removal.
  10.  
  11. Adjust the cables prior to attaching at heater control unit.
  12.  

  1. Disconnect the negative battery cable.
  2.  
  3. Remove heater control panel assembly.
  4.  
  5. Remove heater control cables from control panel assembly.
  6.  
  7. Install control cables by reversing removal procedure, noting the following point. After installing control cables to control levers, move control levers to such position as to pull cables fully, then connect and clamp control cables to heater unit and blower motor unit levers.
    NOTE
    After installing control cables, be sure that control knobs move smoothly and stop at proper position.

  8.  

 
label.common.footer.alt.autozoneLogo