Suzuki Esteem, Swift 1994-02

Fuel Pressure Regulator

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Relieve the pressure from the fuel system.
  4.  
  5. Disconnect the negative battery cable.
  6.  
  7. Disconnect vacuum hose (3) from fuel pressure regulator (1).
  8.  
  9. Disconnect fuel return hose (2) from fuel pressure regulator.
    CAUTION
    A small amount of fuel may be released when hose is disconnected. Cover hose to be disconnected with a shop cloth.

  10.  
  11. Remove pipe clamp bolts.
  12.  
  13. Remove fuel pressure regulator.
    CAUTION
    A small amount of fuel may be released when it is from delivery pipe. Place a shop cloth under delivery pipe so that released fuel is absorbed in it.

  14.  

To install:

  1. For installation, reverse removal procedure and note the following precautions.

    Use new O-ring.
     
    Apply thin coat of spindle oil or gasoline to O-ring to facilitate installation.
     
    Tighten fuel pressure regulator bolts to 8 ft. lbs. (11 Nm).
     
    With engine -OFF- and ignition switch -ON-, check for fuel leaks around fuel line connection.
     

  2.  

 
label.common.footer.alt.autozoneLogo