Suzuki Esteem, Swift 1994-02

Removal & Installation

Print

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Disconnect the negative battery cable.
  4.  
  5. Remove the retaining bolt from the high pressure line and remove the line from the pump.
  6.  
  7. Remove the high pressure hose from the high pressure line.
  8.  
  9. Disconnect the return hose from the reservoir.
  10.  
  11. Disconnect the power steering pressure switch electrical connector.
  12.  
  13. Raise and support the vehicle.
  14.  
  15. Remove the drive belt.
  16.  
  17. Remove the A/C compressor and hang it off to the side if equipped.
  18.  
  19. Remove the power steering pump A/C mounting bracket from the engine.
  20.  
  21. Remove the power steering hose and bracket with the pump from the vehicle.
  22.  
  23. Remove the pump from the mounting bracket.
  24.  
  25. Remove the high pressure line from the pump.
  26.  
  27. Remove the return hose from the pump. To install
  28.  
  29. Install the return hose and the high pressure line to the pump.
  30.  
  31. Bolt the pump to the mounting bracket.
  32.  
  33. Install the assembly to the engine and torque to 64-69 ft. lbs. (47-51 Nm).
  34.  
  35. Install the A/C compressor to the mounting bracket and torque to 17-20 ft. lbs. (23-27 Nm).
  36.  
  37. Install the drive belt.
  38.  
  39. Lower the vehicle.
  40.  
  41. Reconnect the electrical connector to the power steering pressure switch.
  42.  
  43. Reconnect the return hose to the reservoir.
  44.  
  45. Reconnect the high pressure line. Torque components to : high pressure hose retaining bracket bolt to 89 inch lbs. (10 Nm). High pressure hose to high pressure pipe flare nut to 30 ft. lbs. (40 Nm).
  46.  
  47. Fill the power steering reservoir with new power steering fluid.
  48.  
  49. Connect the negative battery cable.
  50.  
  51. Bleed the system.
  52.  

 
label.common.footer.alt.autozoneLogo