Suzuki Forenza, Reno 2003-06

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the glove box.
  4.  
  5. Disconnect the electrical connector at the resistor.
  6.  
  7. Remove the mount screws from the resistor.
  8.  
  9. Remove the resistor from the heater/air distributor case by gently pulling the resistor downward.

    Click image to see an enlarged view

    Fig. Blower motor resistor removal

  10.  

To install:

  1. Install the resistor into the heater/air distributor case with the screws.
  2.  
  3. Tighten the blower motor resistor screws to 11 inch. lbs. (1.2 Nm)
  4.  
  5. Connect the electrical connector at the resistor.
  6.  
  7. Connect the negative battery cable.
  8.  
  9. Confirm the proper performance of the blower.
  10.  
  11. Install the glove box.
  12.  

 
label.common.footer.alt.autozoneLogo