Suzuki Forenza, Reno 2003-06

Removal & Installation

Print

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the glove box.
  4.  
  5. Put the floor carpet aside for preventing stain.
  6.  
  7. Disconnect the blower motor electrical connector and resistor connector.
  8.  
  9. Remove the screws that secure the motor to the heater/air distributor case.

    Click image to see an enlarged view

    Fig. Blower motor and related parts

  10.  
  11. Remove the motor, the seal, and the shock mount pads from the heater/air distributor case by gently pulling the motor straight down and out.

    Click image to see an enlarged view

    Fig. Blower motor removal

  12.  

To install:

  1. Install the blower motor and the seal with the shock mount pads in the heater/air distributor case. Hold the blower motor in position.
  2.  
  3. Install the screws to secure the blower motor to the heater/air distributor case.
  4.  
  5. Tighten the blower motor retaining screws to 11 inch lbs. (1.2 Nm)
  6.  
  7. Connect the blower motor electrical connector and resistor connector.
  8.  
  9. Connect the negative battery cable.
  10.  
  11. Confirm that the blower motor operates properly.
  12.  
  13. Install the glove box.
  14.  

 
label.common.footer.alt.autozoneLogo