Suzuki Forenza, Reno 2003-06

Ignition Switch

Print

Removal & Installation



  1. Disconnect the negative battery cable.
  2.  
  3. Remove the upper and the lower steering column cover panel by removing the screws.
  4.  
  5. With the key in the ignition turned to the position designated ACC, remove the lock cylinder by pressing down the detent spring and pulling the lock cylinder out of the switch cylinder housing.

    Click image to see an enlarged view

    Fig. Lock cylinder removal

  6.  
  7. Remove the ignition switch retaining screw.
  8.  
  9. Disconnect the wiring and remove the ignition switch.

    Click image to see an enlarged view

    Fig. Ignition switch and wiring

  10.  

To install:

  1. Install the ignition switch with the ignition switch retaining screw.
  2.  
  3. Tighten the ignition switch retaining screw to 22 inch. lbs. (2.5 Nm )
  4.  
  5. Connect the wiring to the ignition switch.
  6.  
  7. Install the lock cylinder.
  8.  
  9. Install the upper and the lower steering column cover panel with the screws.
  10.  
  11. Tighten the upper and the lower steering column cover panel screws to 22 inch. lbs. (2.5 Nm)
  12.  
  13. Connect the negative battery cable.

    Click image to see an enlarged view

    Fig. Steering column cover and screws

  14.  

 
label.common.footer.alt.autozoneLogo