Suzuki Forenza, Reno 2003-06

Turn Signal (Combination) Switch

Print

Removal & Installation




CAUTION
Some models covered by this manual may be equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS, as described in Section 6.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the upper and the lower steering column cover panel screws.
  4.  
  5. Remove the upper and the lower steering column cover panels.

    Click image to see an enlarged view

    Fig. Removal of steering column cover

  6.  
  7. Remove the turn signal switch by pushing the tabs on the top and the bottom of the switch housing.
  8.  
  9. Disconnect the electrical connections from the turn signal switch.

    Click image to see an enlarged view

    Fig. Turn signal switch removal

  10.  

To install:

  1. Connect the electrical connections to the turn signal switch.
  2.  
  3. Install the turn signal switch by snapping it into the switch housing.
  4.  
  5. Install the upper and the lower steering column cover panels. Install the upper and the lower steering column cover panel screws.
  6.  
  7. Tighten the upper and the lower steering column cover panel screws to 22 inch. lbs. (2.5 Nm)
  8.  
  9. Connect the negative battery cable.
  10.  

 
label.common.footer.alt.autozoneLogo