Suzuki Vitara, Grand Vitara, XL7 2000-06

Door Glass & Regulator

Print

Power Windows



Diagnosis & Testing
Motor
  1. Check all fuses.
  2.  
  3. Inspect battery condition and connections.
  4.  
  5. Inspect all grounds are clean and tight.
  6.  
  7. Search for applicable service bulletins.
  8.  
  9. Check for voltage and ground at driver-s window motor and switch.
  10.  
  11. With fused connection add voltage and ground to window motor. Reverse connections. Window motor should operate accordingly if not suspect motor.
  12.  

Switch
  1. Remove Master window switch from drivers door panel trim.
  2.  
  3. Inspect switch continuity between terminals.

    Click image to see an enlarged view

    Fig. Power window switch diagnostic diagram

  4.  

Sub Switch
  1. Remove sub switch.
  2.  
  3. Inspect switch continuity between terminal.

    Click image to see an enlarged view

    Fig. Window sub switch continuity diagram

  4.  

Removal & Installation
Motor & Regulator
  1. Remove door mirror trim and door trim screw cover.
  2.  
  3. Remove door trim screw.
  4.  
  5. Remove door trim.
  6.  
  7. Disconnect power window switch lead wire and door illumination lamp lead wire at coupler.
  8.  
  9. Remove door sealing cover.
  10.  
  11. Remove door glass mounting screws.
  12.  
  13. Remove door glass while tilting it.

    Click image to see an enlarged view

    Fig. Door glass removal and mounting screws

  14.  
  15. Disconnect power window motor lead wire at coupler.
  16.  
  17. Remove regulator mounting screws, and then remove front door window regulator.

    Click image to see an enlarged view

    Fig. Window regulator and screws

  18.  

To install:

  1. Install regulator, install and tighten mounting screws.
  2.  
  3. Connect power window motor lead wire at coupler.
  4.  
  5. Install door glass while tilting it.
  6.  
  7. Install and carefully tighten door glass mounting screws.
  8.  
  9. Reattach door sealing cover.
  10.  
  11. Connect power window switch lead wire and door illumination lamp lead wire at coupler.
  12.  
  13. Install door panel trim.
  14.  
  15. Install and tighten door trim screw.
  16.  
  17. Install door mirror trim and door trim screw cover.
  18.  

 
label.common.footer.alt.autozoneLogo