Tercel 1995-1996

Electric Engine Fan

Print

Removal & Installation



Condenser Fan

Specific to:

Toyota Tercel 1995-1996

  1. Disconnect the negative battery cable from the battery. On vehicles equipped with an air bag, wait at least 90 seconds before proceeding.
  2.  
  3. Remove the bolt and remove the air cleaner inlet.
  4.  
  5. Disconnect the electrical connector to the condenser fan.
  6.  
  7. Remove the three bolts and condenser fan.
  8.  

To install:

  1. Install the condenser fan and install the three bolts. Tighten the bolts to 61 inch lbs. (7 Nm).
  2.  
  3. Connect the condenser fan electrical connector.
  4.  
  5. Install the air cleaner inlet with the bolt.
  6.  
  7. Connect the negative battery cable to the battery.
  8.  

Engine Cooling Fan

Specific to:

Toyota Tercel 1995-1996

  1. Disconnect the cable at the negative battery terminal. On vehicles equipped with an air bag, wait at least 90 seconds before proceeding.
  2.  
  3. Remove the engine undercovers, as required.
  4.  
  5. Drain the coolant.
  6.  
  7. Remove the air intake duct.
  8.  
  9. On the 3E-E engine, remove the exhaust manifold heat shroud.
  10.  
  11. On the 5E-FE engine, remove the reservoir tank assembly.
  12.  
  13. Disconnect the upper radiator hose from the radiator.
  14.  
  15. Tag and disconnect the cooling fan switch and oxygen sensor connectors.
  16.  
  17. Remove the mounting bolts and lift out the fan shroud/motor/fan assembly.
  18.  
  19. Unbolt the fan from the shaft, remove the motor mounting bolts and remove the motor from the shroud bracket.
  20.  

To install:

  1. Position the motor in the bracket and tighten the mounting bolts. Press the fan onto the shaft and tighten the bolt.
  2.  
  3. Install the shroud/fan assembly to the radiator.
  4.  
  5. Install the reservoir tank assembly on the 5E-FE engine.
  6.  
  7. Connect the electrical leads, upper radiator hose and refill radiator with coolant.
  8.  
  9. Install the engine undercovers, exhaust heat shroud (if removed), and the intake air duct.
  10.  
  11. Connect the battery negative cable and verify fan operation.
  12.  

 
label.common.footer.alt.autozoneLogo