Tercel 1995-1996

Door Panels

Print

Removal & Installation



Front Door

Specific to:

Toyota Tercel 1995-1996

  1. For vehicles with manual windows, remove the window regulator (crank) handle as follows:
    1. Pull off the regulator handle snap ring with a shop rag, then remove the handle and plate.

      Click image to see an enlarged view

      Fig. A shop rag can be used to remove the snapring securing the regulator handle

    2.  

  2.  
  3. Remove the door inside handle, as follows:
    1. Remove the screw and slide the inside handle forward.
    2.  
    3. Disconnect the inside handle from the control link and remove the inside handle.

      Click image to see an enlarged view

      Fig. Disengaging the links from the door handle lever

    4.  

  4.  
  5. Remove the side view mirror:
    1. For manual mirror, remove the screw and the knob.
    2.  
    3. Use a suitable prytool covered with tape (to protect the prying surfaces), to carefully pry off the cover. Make sure to pry the cover off in the area shown in the accompanying illustration.
    4.  

  6.  
  7. Remove the 3 nuts, then remove the mirror assembly. Unplug the electrical connection on power mirrors.

    Click image to see an enlarged view

    Fig. Carefully pry off the cover in the area shown by the arrow, then remove the 3 mounting nuts



    Click image to see an enlarged view

    Fig. Tape the tip of the tool before prying the door panel loose

  8.  
  9. If equipped with power windows, remove the armrest panel.
  10.  
  11. Remove the armrest cover.
  12.  
  13. Remove the door trim by prying between the retainers with a small prybar (tape the tip before use). On some models it may be necessary to remove the inner weatherstrip on the bottom of the door before removing the trim panel. remove the it by prying between the weatherstrip and the door panel.
  14.  
  15. Installation is the reverse of removal procedure. Handle the door trim panel with care after removal.
  16.  

Rear Door

Specific to:

Toyota Tercel 1995-1996

  1. For vehicles with manual windows, remove the window regulator (crank) handle as follows:
    1. Pull off the regulator handle snap ring with a shop rag, then remove the handle and plate.

      Click image to see an enlarged view

      Fig. A shop rag can be used to remove the snapring securing the regulator handle

    2.  

  2.  
  3. Remove the door inside handle, as follows:
    1. Remove the screw and slide the inside handle forward.
    2.  
    3. Disconnect the inside handle from the control link and remove the inside handle.

      Click image to see an enlarged view

      Fig. Disengaging the links from the door handle lever



      Click image to see an enlarged view

      Fig. Tape the tip of the tool before prying the door panel loose

    4.  

  4.  
  5. Remove the armrest cover.
  6.  
  7. Remove the door trim by prying between the retainers with a small prybar (tape the tip before use). On some models it may be necessary to remove the inner weatherstrip on the bottom of the door before removing the trim panel. remove the it by prying between the weatherstrip and the door panel.
  8.  
  9. Installation is the reverse of removal procedure. Handle the door trim panel with care after removal.
  10.  

 
label.common.footer.alt.autozoneLogo