Toyota Avalon, Camry, Camry Solara 2001-06

Brake Caliper

Print

Removal & Installation



  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove the wheels.
  4.  
  5. Disconnect the brake hose from the caliper.
  6.  
  7. Remove the bolts that attach the caliper to the torque plate. If applicable, hold the flats of the sliding pin with a wrench while loosening the caliper attaching bolts.
  8.  
  9. Lift up and remove the caliper assembly.
  10.  

To install:

  1. Install the caliper and loosely install the bolts.
  2.  
  3. Hold the flats of the sliding pin with a wrench, then tighten the bolts to 25 ft. lbs. (34 Nm).
  4.  
  5. Connect the brake hose to the caliper, using 2 new washers.
  6.  
  7. Fill the brake system to the proper level and bleed the brake system.
  8.  
  9. Add brake fluid to the reservoir to fill to the correct level.
  10.  
  11. Lower the vehicle to the ground.

    Click image to see an enlarged view

    Fig. Front caliper-Camry, Avalon



    Click image to see an enlarged view

    Fig. Rear caliper-Camry, TMC caliper



    Click image to see an enlarged view

    Fig. Rear caliper-Camry, TMMK caliper



    Click image to see an enlarged view

    Fig. Rear caliper-Avalon

  12.  

 
AutoZone Logo