Toyota Avalon, Camry, Camry Solara 2001-06

Fuel Pump

Print

Removal & Installation





Click image to see an enlarged view

Fig. Exploded view for fuel pump removal-Camry shown, others similar

  1. Before servicing the vehicle, refer to the Precautions section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable. Wait at least 90 seconds before performing any other work.
     
    Rear seat bottom and seat back
     
    Rear floor service hole cover
     
    Fuel suction w/pump and gauge tube assembly
     
    8 bolts and fuel tank vent tube set plate
     
    Vapor pressure sensor assembly
     
    Fuel suction hose and support
     
    Fuel pump cushion rubber
     
    Fuel sender gauge assembly
     
    Fuel suction plate w/sender gauge
     
    Fuel pump harness
     
    Fuel pump
     
    Fuel pump filter. Pry out clip and remove from pump
     
    Fuel pressure regulator assembly
     

  4.  

To install:

  1. To install, reverse the removal procedure. Install a new O-ring on the fuel suction w/pump and gauge assembly. Torque the 8 bolts securing the fuel tank set plate to 52 inch lbs. (6.0 Nm).
  2.  
  3. Inspect fuel pump operation and check for fuel leaks.
  4.  



Click image to see an enlarged view

Fig. Exploded view for fuel pump removal-2002-06 Camry , 2002-04 Avalon and 2004-06 Solara



Click image to see an enlarged view

Fig. Exploded view of the fuel pump assembly-2002-06 Camry , 2002-04 Avalon and 2004-06 Solara



Click image to see an enlarged view

Fig. Exploded view of fuel pump removal and components-2002-04 Avalon and 2002-03 Solara

  1. Before servicing the vehicle, refer to the Precautions Section.
  2.  
  3. Remove or disconnect the following:

    Negative battery cable. Wait at least 90 seconds before performing any other work.
     
    Rear seat bottom and seat back
     
    Rear floor service hole cover
     
    Fuel suction w/pump and gauge tube assembly
     
    8 bolts and fuel tank vent tube set plate
     
    Vapor pressure sensor assembly
     
    Fuel suction hose and support
     
    Fuel pump cushion rubber
     
    Fuel sender gauge assembly
     
    Fuel suction plate w/sender gauge
     
    Fuel pump harness
     
    Fuel pump
     
    Fuel pump filter. Pry out clip and remove from pump
     
    Fuel pressure regulator assembly
     

  4.  

To install:

  1. To install, reverse the removal procedure. Install a new O-ring on the fuel suction w/pump and gauge assembly. Torque the 8 bolts securing the fuel tank set plate to 52 inch lbs. (6.0 Nm).
  2.  
  3. Inspect fuel pump operation and check for fuel leaks.
  4.  

 
label.common.footer.alt.autozoneLogo