Toyota Camry 1983-1996 Repair Guide

Seats

Print

REMOVAL & INSTALLATION



See Figures 1 thru 9

Front seats are held to the floor with four bolts each.

The sedan rear seat is retained by two clips at the front and two bolts at the rear. The side seat cushion is held in by one bolt located on the bottom. To remove, lift up and out.



Click image to see an enlarged view

Fig. Fig. 1: When removing the rear lower seat cushion pull from the bottom using force-sedan



Click image to see an enlarged view

Fig. Fig. 2: There are hooks in the back portion of the rear seat bottom

The hatchback rear seat cushion is retained by four bolts, while the seat back is bolted to its hinges.

When installing the seats, tighten the front seat bolts to 27 ft. lbs. (37 Nm); the sedan rear seat bolts to 9 ft. lbs. (12 Nm); the hatchback seat cushion front bolts to 27 ft. lbs. (37 Nm); the hatchback seat cushion rear bolts to 14 ft. lbs. (19 Nm); the seat back-to-center hinge bolts to 69 inch lbs.; the seat back-to-side hinge bolts to 13 ft. lbs. (17 Nm).



Click image to see an enlarged view

Fig. Fig. 3: The side cushions are retained in with one bolt on the bottom



Click image to see an enlarged view

Fig. Fig. 4: Lift the side seat cushion up far enough to detach the hook



Click image to see an enlarged view

Fig. Fig. 5: Front and rear seat mounting-1983-92 models



Click image to see an enlarged view

Fig. Fig. 6: Rear seat mounting-1987-88 models



Click image to see an enlarged view

Fig. Fig. 7: Rear seat mounting-1993-96 sedan and wagon



Click image to see an enlarged view

Fig. Fig. 8: Rear third seat mounting-wagon



Click image to see an enlarged view

Fig. Fig. 9: Front power seat mounting

 
label.common.footer.alt.autozoneLogo