Toyota Camry 1983-1996 Repair Guide

Back-up Light Switch

Print

REMOVAL & INSTALLATION



See Figure 1

  1. Disconnect the electrical harness from the back-up switch, which is mounted on the transaxle case.
  2.  
  3. Remove the ground strap.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: The back-up light switch is located on the top of the manual transaxle

  1. Loosen and remove the back-up light switch from the transaxle case.
  2.  
  3. Remove the gasket. Discard the gasket and purchase a new one.
  4.  

To install:
  1. Install the new gasket onto the switch.
  2.  
  3. Screw the switch and gasket into the transaxle case and tighten to 30 ft. lbs. (40 Nm).
  4.  
  5. Connect the ground strap.
  6.  
  7. Connect the electrical wiring.
  8.  

 
label.common.footer.alt.autozoneLogo