Toyota Camry 1983-1996 Repair Guide

Windshield Washer Motor

Print

REMOVAL & INSTALLATION



See Figures 1, 2, 3 and 4

The windshield washer reservoir motor (pump) is located in the washer reservoir. The same pump is used for the front and rear washers.

  1. Disconnect the negative battery cable.
  2.  
  3. Remove the washer reservoir/motor assembly from the vehicle.
  4.  



Click image to see an enlarged view

Fig. Fig. 1: Unbolt the washer reservoir ...



Click image to see an enlarged view

Fig. Fig. 2: ... then lift it out to access the wiring and hoses

  1. Separate the washer fluid motor wiring from the harness.
  2.  



Click image to see an enlarged view

Fig. Fig. 3: Separate the wiring at the pump motor

  1. Pull the motor from the rubber grommet retaining it to the washer reservoir.
  2.  



Click image to see an enlarged view

Fig. Fig. 4: Pull the motor from the grommet in the reservoir

To install:
  1. Inspect the rubber grommet for deterioration and replace if necessary.
  2.  
  3. Apply petroleum jelly to the motor before inserting it into the grommet.
  4.  
  5. Attach the harness to the pump.
  6.  
  7. Secure the washer reservoir into the engine compartment.
  8.  
  9. Connect the negative battery cable and test the washer pump for operation.
  10.  

 
label.common.footer.alt.autozoneLogo