On vehicles equipped with anti-lock brakes (ABS), please refer to the appropriate procedure in a later section of this Section.
If any maintenance or repairs were performed on the brake system, or if air is suspected in the system, the system must be bled. If the master cylinder has been overhauled or if the fluid reservoir was run dry, start the bleeding procedure with the master cylinder. Otherwise (and after bleeding the master cylinder), start with the wheel cylinder which is farthest from the master cylinder (longest hydraulic line).
See Figures 1, 2 and 3
- Check the fluid level in the master cylinder reservoir and add fluid as required to bring to the proper level.
- Disconnect the brake lines from the master cylinder. Place a few shop rags around the master cylinder port holes.
- Have an assistant depress the brake pedal and hold it in the down position, fluid will spew from the cylinder.
- While the pedal is depressed, block the port holes of the master cylinder with your finger.
- Repeat the procedure three or four times.
- Bleed the brake system, if needed.
See Figures 4, 5, 6 and 7
Start the brake system bleeding procedure on the wheel cylinder that is the furthest away from the master cylinder. To bleed the brakes you will need a supply of brake fluid, a long piece of clear vinyl tubing and a small container that is half full of brake fluid.
- Clean all the dirt and grease from the caliper or wheel cylinder bleeder plug and remove the protective cap. Connect one end of a clear vinyl tube to the fitting.
- Insert the other end of the tube into a jar which is half filled with brake fluid.
- Have an assistant slowly depress the brake pedal while you open the bleeder plug 1 / 31 / 2 of a turn. Fluid should run out of the tube. When the pedal is at its full range of travel, close the bleeder plug.
- Have your assistant slowly pump the brake pedal. Repeat Step 3 until there are no more air bubbles in the fluid.
- Repeat the procedure for each wheel cylinder. Add brake fluid to the master cylinder reservoir every few pumps, so that it does not completely drain during bleeding.