Removal & Installation
- Turn the ignition switch to the LOCK position.
- Disconnect the negative battery cable. Wait at least 90 seconds after the cable had been disconnected to hinder air bag deployment.
- If equipped, remove the distributor cap rubber boot.
- On some models the air cleaner tube may need to be removed to access the distributor cap.
- Loosen the screws securing the cap on the distributor. Depending on your engine you will have two or three screws.
- Tag the wires leading to the cap for easy identification upon installation.
- Lift the cap off the distributor. Pulling from the wire boot, remove the plug wires from the cap.
- If necessary to remove the rotor, some models you simply lift it straight off the shaft. On others, you may need to remove the rotor retaining screws, then lift up the unit.
- On the 1994-95 California 5S-FE engine, align the hollow of the signal rotor with the protrusion tab on the rotor. Install and secure the retaining screws of the rotor.
Do NOT tighten the screws too much, the rotor is made of plastic and could crack.
- On all other models, install the rotor onto the distributor shaft and secure.
The rotor only goes on one way so there should be no mix-up in replacement.
- Apply a small amount of dielectric grease on the tip of the rotor and the inside of the cap carbon ends.
- Attach the tagged wires to their proper locations on the cap.
- Fit the cap onto the distributor, then tighten the bolts securely.
- Make sure all the wires are secure on the cap and spark plugs. Connect the negative battery cable.
- Start the vehicle and check for proper operation.
- Reset any electrical components such as the clock or radio stations.